Tv Menu; Channel Skip - Sharp AQUOS LC-24LE430M Operation Manual

TV menu

Video Audio
Audio Channel
Channels
H Audio Channel
You can switch between multiple audio modes
when watching a multiple audio or stereo broadcast
programme. (Stereo, Dual1, Dual2, Mono) / (NTSC
broadcast Stereo, SAP, Mono)
H Channels
Channel Scan
You can also automatically scan channel by performing
the procedure below.
1
Go to "MENU" > "TV" > "Channels" > "Channel
Scan", and then press ENTER.
2
Press a / b to select "TV System".
3
Press c / d to select the optimum TV systems
(Broadcasting system) to receive.
(Auto, B/G, A2 B/G, I, D/K, A2 D/K, A2 D/K1,
A2 D/K2, M)
4
Press ENTER.
5
Press c / d to select "OK", and then press
ENTER. Channel Scan will start.
You do not need to do anything during the
channel scan.
NOTE
• Check the TV System if the sound output is not correct.
Update Scan
You can add channel by performing Update Scan. Use
this menu to add new services automatically after the
initial auto installation has been completed.
• Start searching channels after selecting the colour system
and sound system.
Analogue Manual Scan
You can adjust the frequency to your desired
position.
Start Set by directly entering the frequency
Frequency number of the channel with 0 – 9 on the
(MHz) remote control.
Scan Up The higher frequency channel will be
searched in order.
Scan Down The lower frequency channel will be
searched in order.
TV Setup Parental
Stereo

Channel Skip

Selected channels are passed over when using
CH a / b even if selected while watching the image
from the TV.
1
Go to "MENU" > "TV" > "Channels" > "Channel
Skip", and then press ENTER.
2
Press a / b to select the channel you want to
skip.
3
Press ENTER.
When is displayed, the channel is set to SKIP.
Channel Sort
Channel position can be sorted freely.
1
Go to "MENU" > "TV" > "Channels" > "Channel
Sort", and then press ENTER.
2
Press a / b to select the channel you want
to move, and then press ENTER.
will be displayed.
3
Press a / b to move it to the desired position,
and then press ENTER.
4
Repeat the step 2 and 3 until all desired
channels are sorted.
Channel Edit
When a TV channel sends its network name,
the initial auto installation detects the information and
assigns a name to it.
However, you can change individual channel names.
1
Go to "MENU" > "TV" > "Channels" > "Channel
Edit", and then press ENTER.
2
Press a / b to select the desired channel you
want to edit, and then press ENTER.
3
Press a / b to select "Channel Name", then
select each character of the new name for the
channel using keys as in the table below.
Press and
continuously
A B C 1 A  - - -
1
D E F 2 D  - - -
2
G H I 3 G  - - -
3
J K L 4 J  - - -
4
M N O 5 M  - - -
5
P Q R 6 P  - - -
6
S T U 7 S  - - -
7
V W X 8 V  - - -
8
Y Z 9 Y  - - -
9
+ – • 0 + - - -
0
NOTE
• If you want to delete a character, press c .
4
Repeat until the name is fully spelt out.
Selectable character
9