Setting The Clock - Sharp XL-MP45H Operation Manual

Setting the clock

XL-MP45H
ENGLISH
This may be operated only with the remote control.
In this example, the clock is set for the 24-hour (0:00) display.
1
Press the CLOCK button and within 3 seconds, press the
MEMORY button.
2
Within 30 seconds, press the PRESET (
select 24-hour or 12-hour display and then press the MEM-
ORY button.
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
Note that this can only be set when the unit is first installed or it
has been reset. [Refer to "Clearing all the memory (reset)" on
page 29 for details.]
E-9
3
Within 30 seconds, press the PRESET (
adjust the hour and then press the MEMORY button.
" Press the PRESET (
by 1 hour. Hold it down to advance continuously.
" When the 12-hour display is selected, "AM" will change au-
tomatically to "PM".
4
Within 30 seconds, press the PRESET (
adjust the minutes and then press the MEMORY button.
" Press the PRESET (
by 1 minute. Hold it down to advance continuously.
" The hour will not advance even if minutes advance from "59"
to "00".
To confirm the time display when the power is on:
Press the CLOCK button.
or ) button to
The time display will appear for about 3 seconds.
Note:
The "CLOCK" or time will flash when the AC power supply is
restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from the beginning. If the time is flash-
ing, step 2 (for selecting the 24-hour or 12-hour display) will be
skipped.
To change the 24-hour or 12-hour display:
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 29 for details.]
2 Perform "Setting the clock" from the beginning.
03/8/20 XL-MP45H(H)E1.fm
or ) button to
or ) button once to advance the time
or ) button to
or ) button once to advance the time
TINSZ0227SJZZ
14