Getting started
Connecting the base with the phone network and the mains
power supply
3
2
Please note:
u
The charger cradle must always be connected, as the phone will not operate without a
power supply
u
Use only the charger cradle and phone cord supplied. Pin connections on telephone cables
can vary
Connecting the charger (if included)
2
6
4
1
¤
Connect the flat plug to the charger cradle
¤
Plug the charger cradle into the plug socket
4
If you have to remove the plug from the charger again:
¤
Disconnect the charger cradle from the mains
1
power supply
¤
Press the release button
plug
3
¤
Plug the telephone cable into the con-
nection socket
base until it clicks into place, then push
the cable into the clips
¤
Plug the charger cradle cable into the
socket
2
on the back of the base and
press firmly to ensure the power sup-
ply. It is important to twist the angle
plug underneath the cable clips to
ensure a firm fit
¤
First, connect the charger cradle
¤
Then connect the phone jack
3
4
1
on the back of the
3
4
1
2
and disconnect the
el en