Rear Wheel - Yamaha TT-R110EY Owner's Manual

7. Remove the brake shoe assembly
from the wheel hub by pulling it
out.
1
1. Brake shoe assembly
8. Remove the wheel.
To install the front wheel
1. Install the brake shoe assembly
into the wheel hub.
2. Lift the wheel up between the fork
legs.
TIP
Make sure that the slot in the brake
shoe plate fits over the retainer on the
fork leg.
PERIODIC MAINTENANCE AND ADJUSTMENT
1. Slot
2. Retainer
3. Insert the wheel axle from the
right-hand side, and then install
the washer and the axle nut.
4. Lower the front wheel so that it is
on the ground.
EAU41692
5. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
35 Nm (3.5 m·kgf, 25 ft·lbf)
6. Adjust the brake lever free play.
(See page 7-17.)
7. While applying the front brake,
push down hard on the handlebar
several times to check for proper
fork operation.

Rear wheel

2
To remove the rear wheel
1
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Disconnect the brake torque rod
1. Brake torque rod
2. Cotter pin
3. Brake torque rod bolt and nut
4. Brake shoe plate
7-29
WARNING
from the brake shoe plate by re-
moving the cotter pin, the nut and
the bolt.
EAU25080
EAU41643
EWA10821
7