Yamaha TT-R110EY Owner's Manual page 41

2
3
4
1. Engine oil filler cap
2. Dipstick
3. Maximum level mark
4. Minimum level mark
TIP
The engine oil should be between the
minimum and maximum level marks.
4. If the engine oil is at or below the
minimum level mark, add sufficient
oil of the recommended type to
raise it to the correct level.
5. Insert the dipstick into the oil filler
hole, and then tighten the oil filler
cap.
PERIODIC MAINTENANCE AND ADJUSTMENT
To change the engine oil
1. Start the engine, warm it up for
several minutes, and then turn it
1 off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap
and drain bolt to drain the oil from
the crankcase.
1. Engine oil drain bolt
4. Install the engine oil drain bolt, and
then tighten it to the specified
torque.
Tightening torque:
Engine oil drain bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)
NOTICE
1
7-9
5. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the engine
oil filler cap.
Recommended engine oil:
See page 9-1.
Oil change quantity:
0.80 L (0.85 US qt, 0.70 Imp.qt)
G In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
G
Make sure that no foreign mate-
rial enters the crankcase.
ECA11620
7