Cleaning And Lubricating The Drive Chain - Yamaha TT-R110EY Owner's Manual

TIP
Using the alignment marks on each
side of the swingarm, make sure that
both adjusting nuts are in the same po-
sition for proper wheel alignment.
1. Axle nut
2. Drive chain slack adjusting nut
3. Locknut
4. Alignment marks
3. Tighten both locknuts and the axle
nut to the specified torques.
Tightening torques:
Locknut:
7.0 Nm (0.7 m·kgf, 5.1 ft·lbf)
Axle nut:
60 Nm (6.0 m·kgf, 43 ft·lbf)
PERIODIC MAINTENANCE AND ADJUSTMENT
4. Adjust the brake pedal free play.
(See page 7-18.)
7-21
Cleaning and lubricating the
drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
NOTICE
The drive chain must be lubricated
after washing the motorcycle and
riding in the rain.
1. Remove all dirt and mud from the
drive chain with a brush or cloth.
TIP
For a thorough cleaning, have a
Yamaha dealer remove the drive chain
and soak it in solvent.
2. Spray Yamaha Chain and Cable
Lube or a high-quality spray-type
drive chain lubricant on both sides
and on the middle of the chain,
EAU23013
ECA10581
7