Horizontal & Vertical Position Adjustment - Mitsubishi Electric WD-60C10 Service Manual

MODELS: WD-60C10 / WD-65C10 / WD-73C10 / WD-60638 / WD-65638 / WD-73638 /
WD-60738 / WD-65738 / WD-73738 / WD-82738 / WD-65838 / WD-73838 / WD-82838
V43C & V43
Horizontal and Vertical Position Adjustment
1. Enter the Service Menu <MENU><2-4-7-0> .
2. Select "Calibration" <ENTER>. The raster will blank out.
3. Enter the H & V Position adjustment by pressing <2-8-4-6>. The geometry pattern below will be displayed
and the STATUS LED will blink Green at a 1 second interval during the alignment..
4. Use the Navigation <
5. Press <ENTER> to save the adjustment data. The STATUS LED will turn Red while the data is saved.
V43+ & V43++
Horizontal and Vertical Position Adjustment
1. Enter the Service Menu <MENU><2-4-5-7> .
2. Select the Geometry Test Pattern shown Play < > Rewind
3. If necessary, use the <VIDEO> button to select the adjustment, "1.HVPOS".
4. After selecting the HVPOS adjustment item, use the Navigation <
5. Press <ENTER> to save the adjustment data. The on-screen display will flash red while the data is saved.
ADJUSTMENT PROCEDURES
V43C & V43 Vertical & Horizontal Position Adjustment
<MENU><2-4-7-0> "Calibration" <ENTER><2-8-4-6>
> buttons to center the display.
V43 & V43+ Vertical & Horizontal Position Adjustment
<MENU><2-4-5-7> < > <
SERVICE
TVM
1.HVPOS
< > x2.
> < >
Adjustment
Data (HPOS)
-3
Data (VPOS)
4
> buttons to center the display.
Page 34