Troubleshooting - Central Machinery 32650 Set Up And Operating Instructions Manual

Problem
Tool will not start. 1.
2.
3.
Tool operates slowly. Extension cord too long or wire size
too small.
Performance 1.
decreases over time.
2.
Excessive noise or 1.
rattling.
2.
Overheating. 1.
2.
3.
4.
5.
Follow all safety precautions whenever diagnosing or servicing the tool.
disconnect power supply before service.
Page 22

Troubleshooting

Possible causes
Cord not connected.
No power at outlet.
Internal damage or wear.
(Carbon brushes or switch, for
example.)
Accessory dull or damaged.
Carbon brushes worn or
damaged.
Belt too loose (slipping) or too
tight (bearing damage).
Internal damage or wear.
(Carbon brushes or bearings, for
example.)
Forcing material into blades too
fast.
Accessory misaligned.
Accessory dull or damaged.
Blocked motor housing vents.
Motor being strained by long or
small diameter extension cord.
For technical questions, please call 1-800-444-3353.
likely Solutions
1. Check that cord is plugged in.
2. Check power at outlet. If outlet is unpowered,
turn off tool and check circuit breaker. If breaker
is tripped, make sure circuit is right capacity for
tool and circuit has no other loads.
3. Have technician service tool.
Eliminate use of extension cord. If an extension
cord is needed, use shorter/heavier gauge cord.
See Extension Cords in GROUNDING section.
1. Keep cutting accessories sharp. Replace as
needed.
2. Have qualified technician replace brushes.
1. Properly tension belt.
2. Have technician service tool.
1. Allow machine to work at its own rate.
2. Check and correct accessory to fence and/or
table alignment.
3. Keep cutting accessories sharp. Replace as
needed.
4. Wear ANSI-approved safety goggles and NIOSH-
approved dust mask/respirator while blowing dust
out of motor using compressed air.
5. Eliminate use of extension cord. If an extension
cord is needed, use one with the proper diameter
for its length and load. See Extension Cords in
GROUNDING section.
SKU 32650