Troubleshooting Guide - Central Machinery 45656 Operating Instructions Manual

Turntable rotates in only one direction.
Reverse Pedal (59E) broken.
Turntable does not rotate.
Belt (16D) broken.
Reverse Pedal (59E) broken.
Problem with Motor (10D).
Turntable locks while mounting/removing tire.
Belt loose.
Jaws (17C) slow to open/close.
Silencer (36 E) clogged.
Turntable does not lock the wheel rim correctly.
Jaws worn.
Defective Piston (26C).
Tool touches the wheel rim during tire mounting/removing process.
Locking Plate (12C) incorrectly
adjusted or defective.
Plate Locking Screw (14C) loose.
Bead Breaker pedal and Jaw Clamp pedal lock out of position.
Return Spring (24E) broken.
Bead breaking operation difficult.
Silencer (36E) clogged.
Valve Shaft O-Ring (31E) broken.
For your safety, major service and repair procedures should be performed by a qualified
technician. Replace or repair damaged or worn parts immediately. Use only identical
replacement parts. Only use accessories intended for use with this product. Approved
accessories are available from Harbor Freight Tools.
SKU 45656 For technical questions, please call 1-800-444-3353.

TROUBlESHOOTING GUIDE

Check entire Reverse Assembly.
Replace Belt
Check entire Reverse Assembly.
Check for loose wires in the Motor,
Plug, or Socket. Replace Motor.
Adjust Belt Tension.
Clean or replace Silencer.
Replace Jaws.
Replace Plate Cylinder Gaskets (23C).
Adjust, or replace Locking Plate.
Tighten Screw.
Replace Spring.
Clean, or replace Silencer.
Replace O-Ring.
WARNING:
Page 16