Tuning In To A Preset Station; Scanning Broadcast Stations (Only For Ks-F525) - JVC KS-FX725R Service Manual

2
Tune in to a station (in this example,
of 88.3 MHz).
Press ¢
in to stations of higher
frequencies.
Press 4
in to stations of lower
frequencies.
3
Press and hold the number button
(in this example, 1) for more than 2
seconds.
"P 1" flashes for a few seconds.
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new station
is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.

Tuning in to a preset station

You can easily tune in to a preset station.
Remember that you must store stations first. If you
to tune
have not stored them yet, see "Storing stations in
memory" on pages 8 and 9.
1
Select the band (FM1 – 3, AM).
to tune
2
Select the number (1 – 6) for the preset
station you want.
Scanning broadcast stations
(only for KS-F525)
When you press SCAN while listening to the
radio, station scanning starts.
If you want to listen to that program, press the
same button again to stop scanning.
KS-FX725R
FM1 FM2
KS-F525
FM1
AM
Each time a broadcast is tuned
SCAN
in, scanning stops for about 5
seconds (tuned frequency
number flashes on the display),
and you can check what program
is now being broadcast.
FM3 AM
FM2 FM3
9