Advertisement
operation
adjusting the handle assembly
1.
Determine if you will need a moderate or
large amount of leverage for the job.
Figure 6 -- Adjusting the Shaft
2.
Loosen the LOCK PIN (#11) by turning it
as shown in Figure 6. This will allow you
to adjust the length of the SHAFT (#15).
3.
Adjust the length of the SHAFT to
suit your needs. If a large amount of
leverage is needed for your press job,
lock the SHAFT in the extended position.
If a moderate amount of leverage is
needed, position the SHAFT in the
middle of the GEAR.
4.
Tighten the LOCK PIN to secure the
Handle Assembly.
The following Steps show the SHAFT in
the extended position.
SKU 03551 03552
For technical questions, please call 1-800-444-3353.
Lock Pin (#11)
Shaft (#15)
1.
Raise the RACK (#10) up by turning the
Handle Assembly as shown in Figure 7.
2.
Turn the PLATE (#6) until the appropriate
width opening is centered under the
RACK. The appropriate width depends
upon what you are using the press for.
If you do not want an opening beneath
the RACK, rotate the PLATE until one
of the four solid parts of the PLATE is
underneath the RACK.
3.
Place the part you need to press onto
the PLATE.
4.
Turn the Handle Assembly to lower the
RACK until the top of the RACK contacts
the press part.
5.
Place downward pressure on the Handle
Assembly to press the part as needed.
6.
Release pressure on the Handle
Assembly and raise the RACK to remove
the part.
using the arbor press
Figure 7 -- Raising the Rack
Rack (#10)
Shaft (#15)
Plate (#6)
Page 6
Advertisement
