Assembly And Operation - Central Machinery 90757 Assembly And Operating Instructions Manual

8” mini shear brake

Table of Contents

Handle (31)

Handle Bolt (29)

Driving Gear (30)

1. Mount the Shear Brake by driving the 4 mounting bolts (not included) through the 11/16"

mounting holes, into your workbench. Secure each bolt in place with included washer and

nut. Make sure the workbench is level and solid enough to support the Brake Shear, the

workpieces, and the pulling force associated with operation of the tool.

See FIGURE 1.

2. Insert the Handle (31) into the Driving Gear (30) and secure it with the Handle Bolt (29).

See FIGURE 1.

Inserting the Lower Bending Die (2)

Note: The Lower Bending Die (2) is reversible and can be inserted using either the top or

bottom, depending on the thickness of the metal you are working with.

1. To insert the Lower Bending Die 2, slide the smaller end first, into the bottom of the ma-

chine as shown in FIGURE 2. The rear side of the Lower Bending Die (2) is shown on the

back side of the Shear Brake in FIGURE 1. Make sure the Lower Bending Die (2) lines up

with the upper Dies (3, 37-41). FIGURE 3 shows the front side of the unit with the Lower

Bending Die (2) installed.

FIGURE 2

Front Side of

Lower Bending Die (2)

SKU 90757