Table of Contents
Advertisement
IMPORTANT: Clean the Spray Gun IMMEDIATELY after use.
Improper cleaning will cause the Spray Gun not to work properly.
Materials dry quickly which will render the gun useless.
It is extremely difficult to remove dry paint from small passages within the Gun.
USER-MAINTENANCE
INSTRUCTIONS
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
FROM ACCIDENTAL
OPERATION:
Detach the air supply, safely
discharge any residual air
pressure in the tool, and
release the trigger before
performing any inspection,
maintenance, or cleaning
procedures.
TO PREVENT SERIOUS
INJURY FROM TOOL
FAILURE:
Do not use damaged
equipment. If abnormal
noise, vibration, or leaking
air occurs, have the problem
corrected before further use.
Cleaning, Maintenance, and
Lubrication
Note: These procedures are in addition to
the regular checks and maintenance
explained as part of the regular op-
eration of the air-operated tool.
Solvent Selection
Follow the paint manufacturer's rec-
ommendations for cleaning, solvent
type, and disposing of used solvent.
For technical questions, please call 1-800-444-3353.
SKU 66871
TO PREVENT
SERIOUS INJURY
Troubleshooting section near end of manual.
1.
Latex Paints: Use warm, soapy
water.
IMPORTANT: Do not use mineral
spirits on latex paints or the mixture
will congeal, making it very difficult to
remove.
2.
Oil Based Paints: Use mineral spir-
its.
WARNING! TO PREVENT
FIRE, IF A FLAMMABLE
SOLVENT NEEDS TO BE
USED, ADHERE TO THE
FOLLOWING:
3.
Follow all of the solvent manufactur-
er's clean up instructions and safety
precautions at all times.
4.
Flush the Spray Gun a full hose
length from the air compressor.
5.
If collecting flushed solvents into a
metal container, transfer into a large
nonmetal container, and flush the
metal container.
6.
Work far away from any ignition
sources in a vapor free area.
After each use:
1.
Empty the Paint Cup and clean it with
the solvent.
2.
Fill the Paint Cup with solvent and
spray it through the Spray Gun into
a container, while shaking the spray
gun. Once the Paint Cup is empty,
repeat the process until the solvent
comes out clean.
3.
Disconnect from the air source.
Page 13
Hide quick links:
Advertisement
Table of Contents
