Pairing; Sleep Mode And Initial Settings - Suunto M4 User Manual

Pairing

: skip pairing
●
SKIP
: pair HR belt
●
BELT
NOTE: Sounds do not work while the backlight is on.

13.1 Sleep mode and initial settings

To change the initial settings, you have to put the device into sleep mode.
To put the device into sleep mode:
1. After the last step of general settings, when the device asks you to confirm
that the setting changes are done, keep
into sleep mode.
2. Press any button to activate the device again.
3. Set the initial settings, see Chapter 4 Getting started on page 8.
NOTE: When replacing the battery, only the time and date change. The device
remembers your previous initial settings and recorded exercises.
Example: adjusting alarm settings
When the alarm is on, is shown on the display.
To set the alarm on/off:
1. In the time view, keep
2. Browse to
ALARM
3. Set the alarm
ON
4. Set the alarm time with
pressed to enter the settings.
with and confirm with
or with and
OFF
and
pressed until the device goes
.
. Confirm with
. Confirm with .
.
29
en