Wolf CT15I Use & Care Information Manual page 9

W O L F I N D U C T I O N C O O K TO P
R E S I D UA L H E AT I N D I C A T O R S
As an additional safety precaution, residual
heat indicator lights will illuminate when the
surface temperature of the glass is above 150˚F
(65˚C). Each heating element has an independ-
ently controlled light located to the right of the
element as shown in the illustration. Even if
the cooktop controls are turned off, you are
alerted to any area of the cooktop that remains
hot.
Do not set griddles or oversized pans on
residual heat indicator lights.
Location of
indicators
Residual heat indicators
U S E & C A R E
I N I T I A L S TA RT- U P
Before operating the cooktop, please read the
entire Use & Care Information.
Clean the cooktop surface as outlined in the
Ceramic Glass Top Cleaning section on page
12. The cooktop surface must be free of any
foreign substance, especially those that could
melt and permanently adhere to the glass.
During the first uses of your new induction
cooktop, you may smell a slight burning odor
or see light smoke. Both of these conditions
are normal in new ceramic glass cooktops.
NOTE: A sound may be detected when the
cooktop begins operation. This is normal.
IMPORTANT NOTE: When the cooktop is
powered up for the first time, the unit will
default to Lock mode. To unlock the control
panel, refer to the Lock Mode section on
page 8.
Make sure that the cooktop surface is
clean and dry before operating.
Do not place hot cooking utensils directly
over control panel.
9