Maintenance And Servicing; A) Vacuum Cleaner Storage; B) Cleaning Exterior And Accessories - Panasonic MC-UL672 Operating Instructions Manual

MAINTENANCE AND SERVICING

Always follow all safety precautions when cleaning and servicing the vacuum cleaner.
WARNING: Electrical Shock And Personal Injury Hazard
Disconnect from electrical supply before servicing or cleaning the vacuum cleaner. Failure to do so could result in
electrical shock or personal injury from vacuum cleaner suddenly starting.

A) VACUUM CLEANER STORAGE

Operating
Position
Handle
Storage
Release
Position
To return the handle to the storage position when the vacuum cleaner is not
Button
in use, press handle release button and push the handle down for easy
storage.
NOTE: You should hear a noticeable "click" sound when handle reaches the
storage position.

B) CLEANING EXTERIOR AND ACCESSORIES

CAUTION:
Do not use attachments if they are wet.
should not be used on other surfaces until they are washed. They could leave marks.
Disconnect mains plug from wall outlet.
Clean exterior using a clean, soft cloth that has been dipped in a solution of mild liquid detergent and water, then wrung dry. Wipe
dry after cleaning. DO NOT drip water on vacuum cleaner.
Wash attachments in warm soapy water, rinse and air dry. Do not clean in dishwasher.
DO NOT use accessories if they are wet.
ttachments used in dirty areas, such as under a refrigerator,
A
- 8 -
1 4
Motor
Shaft
Belt
Pulley
Belt
Pulley
1 5
End
Cap
Agitator
Nozzle Base
Base Slot
1 6
Belt
Agitator
1 7
Tab
Nozzle
Cover
Tab
Nozzle Cover
Retainer
TO REPLACE BELT
Seat left end of agitator into nozzle base. To seat agitator
end, place rounded portion of agitator end cap down into slot
in nozzle base.
Loop the new belt on the belt pulley.
Loop the other end of belt onto the belt pulley on the right
end of agitator.
Pull right end of agitator forward and seat it into nozzle base.
Press firmly, checking to see that each end is completely
inserted.
Check to see that the belt is centered on the belt pulley and
that the agitator turns freely.
Make sure the nozzle cover retainers are in the UNLOCK
position. Hook the front of the nozzle cover on to the nozzle
base and rotate downward. Make sure tabs snap in. Once in
place, rotate the nozzle cover retainers to the LOCK
position.
- 13 -