Panasonic SC-HT05 Operating Instructions Manual page 5

Supplied
Speaker stands
accessories
3
Adjust the speaker height.
e.g., With the stand attached
to the lower rear of the
speaker
Stopper screw
Screw to stop mounting
plate from moving or
sliding below this point.
4
Connect the speaker cables.
Copper
Silver
5
Fasten the speaker cable to the base.
Preventing the speakers from falling over
Attach screw eyes (not included) to secure the speakers to a wall
(diagram on the right).
• Obtain the screws appropriate to the walls and pillars to which the they
are going to be fastened.
• Consult with a qualified housing contractor concerning the appropriate
procedure when attaching to a concrete wall or a surface that may not
have strong enough support. Improper attachment may result in
damage to the wall or speakers.
Stand bases
(x 4)
1
Loosen the attached speaker mounting plate screw until the
attached speaker is slightly loose and adjustable.
• Be careful not to loosen the screw too much or the speaker may
detach and fall.
2
Adjust the position of the pipe.
• After adjusting the height, tighten the screw on the mounting plate
securely.
1
Connect the speaker cables.
2
Press the speaker cable into the groove.
If there is any excess cable, thread it from the opening near the top of
the pipe while pulling it from the bottom of the base.
1
Press the speaker cable and thread between the hooks.
2
Fit the speaker cable into the base cover groove as far as
possible.
Screws (large and small)
(x 8)
(x 8)
(x 4)
Wall
5