Panasonic SC-BFT800 Operating Instructions Manual page 20

≥ If you can not find the SSID*
2 Press [RETURN] and then press [OK].
Then select an item on the following screen which
corresponds to the authentication type noted down in step
1 ( 19).
Access Point Connection Setting
Select authentication type.
Follow the on-screen instructions to make the settings.
≥ Input your encryption key code in "Encryption Key"
supplied with your Wireless router (Access point).
*1 Wi-Fi Protected Setup-compatible Wireless router (Access point) may
have the mark.
*2 An SSID (Service Set IDentification) is a name used by wireless LAN to
identify a particular network. Transmission is possible if the SSID
matches for both devices.
When you experience
problems with settings
Access Point Connection Setting
Access Point Connection Setting
Failed to connect to the access point.
A conflict with other devices occurred.
Do you wish to setup Access Point
Connection Setting again ?
OK
Display
A conflict with other
devices occurred.
A time out error occurred.
An authentication error or a
time out error occurred.
A device error occurred.
VQT2Z56
20
2 , select "Search again".
WPA2-PSK (AES/TKIP)
WPA-PSK (AES/TKIP)
Open/Shared Key (WEP)
Open system
Yes No
Check the following
≥ Please wait a few moments,
and then try again.
≥ Setting of the Wireless
router (Access point) for
MAC Address etc.
≥ The signal may be weak.
Using the USB extension
cable supplied with the
Wireless LAN Adaptor,
adjust the position of the
Wireless LAN Adaptor.
≥ The SSID and the
encryption key of the
Wireless router (Access
point).
≥ Please wait a few moments,
and then try again.
≥ Connection of Wireless LAN
Adaptor
If there is no improvement in
symptom, consult your
dealer.
Network Easy Setting (Connection Test)
Network Easy Setting (Connection Test)
Complete.
1. LAN cable connection
2. IP address setting
3. Connection to gateway
LAN cable is not connected.
Please check the connection.
Select "Yes" and press [OK] to check network
connection again.
Select "No" and press [OK] to finish Network
Easy Setting.
Yes
OK
Display
1. LAN cable connection or
Connection to access point
2. IP address setting
3. Connection to gateway
1. LAN cable connection or
Connection to access point
2. IP address setting
3. Connection to gateway
1. LAN cable connection or
Connection to access point
2. IP address setting
3. Connection to gateway
1. LAN cable connection or
Connection to access point
2. IP address setting
3. Connection to gateway
Network Easy Setting (Internet Connection Test)
Network Easy Setting (Internet Connection Test)
Complete.
- Connection to the Internet
Failed the connection test.
Cannot find the server.(B019)
Please refer to the operating instructions for the cause
of the error and the countermeasure for it.
Press [OK].
OK
Display
≥ "Primary DNS" and "Secondary
Cannot find the server.
(B019)
≥ The server may be busy or the
Failed to connect to
the server.
(B020)
≥ Settings of "Proxy Server
: Fail
: Fail
: Fail
No
Check the
following
≥ Connection of
:Fail
the LAN
cables (
:Fail
:Fail
≥ Connection
:Pass
and settings
of the hub
:Fail
and router
:Fail ≥ Settings of
"IP Address /
:Pass DNS
Settings"
:Home ( 41)
network
available
:Fail
:Pass
:Pass
:Fail
: Fail(B019)
Check the following
DNS" settings of "IP Address /
DNS Settings" ( 41)
service may have been
suspended. Please wait a few
moments, and then try again.
Settings" ( 41) and the router
17)