Presetting Radio Broadcasts.10 - Panasonic SC-AK20 Operating Instructions Manual

Presetting radio broadcasts
• Up to 12 stations can each be set in the FM and AM bands
automatically.
• If broadcast frequencies are preset in the memory, you can easily
tune in any of these frequencies from the system or remote control
unit.
• You can preset just those stations you like. (See "Presetting only
your favorite stations" below.)
Press TUNER BAND to select "FM" or "AM".
The power will come on automatically.
Every time you press the button; "FM" <—> "AM".
Press TUNE MODE to select "MANUAL".
Every time you press the button; "MANUAL" <—> "PRESET".
□
Press
V
or
A
until the display shows the frequency
from which you want to begin automatic memory
presetting.
Tips on tuning in radio stations
(T) Hold down either arrow button until the frequency
numbers start scrolling.
@ When near to the frequency you are looking for, press the
button repeatedly until tuning the broadcast in.
Press and hold MEMORY/SET until the frequency
begins to change.
This will start presetting automatically. When finished, the
radio will tune in last station memorized.
If auto presetting is not possible because radio signals are
weak or for some other reason, do the following.
Presetting only your favorite stations
Preset the stations one at a time.
1. Perform above steps 1 and 2. Then, select a station with V and
A, and press MEMORY/SET. "PRGM" will flash on the display.
2. While "PRGM" is flashing, select a preset channel with V or A,
and press MEMORY/SET again. "PRGM" will go out and the
station will be stored in memory.
FM allocation setting
By adjusting the allocation, you can enable this tuner to receive FM
broadcasts allocated in 0.1 MHz steps.
1. Press and hold TUNER BAND for approximately 5 seconds.
The frequency display will be returned to the minimum frequency
of the FM band and the display will begin to flash.
Keep holding for approximately 5 more seconds.
2. When the display stops flashing and indicates a different fre¬
quency number, release TUNER BAND.
To return to the original frequency, repeat steps 1 to 2 above.
After changing the "allocation" setting, the frequencies you previ¬
ously preset in the memory will be cleared.
Memory retention
Your preset is retained in memory for about 2 weeks while the sys¬
tem is unplugged.