Installing The Water Filter - Samsung French Door Refrigerator User Manual

Setting up your French
Door Refrigerator

Installing the water filter

1. Remove the water filter cover(
2. Remove the fixed cap by turning it
counter clockwise. Keep the cap
in a safe place for later use if you
don't use a filter.
3. Remove the water filter from
the box and put a replacement
indicator sticker on the filter as
shown. Place a sticker on the
filter that dates six months in the
future. For example, if you install
the water filter in March, put the
"SEP" sticker on the filter to remind
you to replace in September. That
way you'll know when it is time to
replace the filter. Normally, a filter
life is about 6 months.
4. Remove the filter cap and insert the
filter into the filter housing.
5. Slowly turn the water filter 90º
clockwise to align with the printing
mark on the cover, locking the filter
in position. Make sure to align the
water filter label mark with center
of cover filter printing as illustrated.
Remember, do not over-tighten.
You should remove the right side upper glass shelf before installing water
filters.
Removing any residual matter inside the water supply line
after installing the water filter.
1. Turn ON the main water supply.
2. Run water through the dispenser until the water runs
clear 3L. This will clean the water supply system and
remove air from the lines.
3. Additional flushing may be required in some
households. But , the filter will have an operational life
proportional to the quality of the water supplied). The
time is not guaranteed.
4. Open the Refrigerator door and make sure there are no
water leaks coming from the water filter.
Be sure to flush the dispenser thoroughly, otherwise water may drip from
the dispenser. This means that there is still air in the line.
)
1
2
4
Separation
of red cap.
1
3
Sticker
(month indicator)
Cover filter.
5
Turn until the
labels are
aligned.
Setting Up_15