Removing The Residual Matter Inside The Water Supply Line After Installing The Water Filter; Reverse Osmosis Water Supply - Samsung RF4287HAWP User Manual

When you pull the water filter, a little of water can be leaked. It is normal.
To minimize the water leak, keep the filter cartridge horizontal or down the grip when you pull it.
In order to prevent overflow, empty the tray water filter ( 3 ). And dry
around of case filter ( 2 ).
3. Insert new one into the case filter ( 4 )
4. Push and turn the water filter clockwise, until it locked.
%
®
If you are in trouble of inserting the water filter as high pressure of water
the water supply valve.
The locked symbol should be lined up with the indicator line.
shut off
5. After above steps, press the "Alarm/hold 3 see for Filter Reset" button _'_)
(Filter Reset)
) for about 3 seconds to reset the water filter. The color of indicator ( u2 ) will be changed from Red to
Blue.
Removing any residual matter inside the water supply line after installing the water filter.
1. Turn ON the main water supply and supply water from water supply line.
2. Run water through the dispenser until the water runs clear (approx. 6-7 minutes).
This will clean the water supply system and remove air from the lines.
3. Additional flushing may be required in some households.
4. Open the Refrigerator door and make sure there are no water leaks coming from
the water filter.
Be sure to flush the dispenser thoroughly, otherwise water may drip from the dispenser.
This means that there is still air in the line.
Reverse Osmosis Water Supply
IMPORTANT : The pressure of the water supply coming out of a reverse osmosis system going to the water
inlet valve of the refrigerator needs to be between 35 and 120 psi (241 and 827 kPa).
If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the
reverse osmosis system needs to be a minimum of 40 to 60 psi (276 to 414 kPa.)
If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa):
,, Check to see whether the sediment filter in the reverse osmosis system is blocked. Replace the filter if
necessary.
,, Allow the storage tank on the reverse osmosis system to refill after heavy usage.
,, If your refrigerator has a water filter, it may further reduce the water pressure when used in conjunction
with a reverse osmosis system. Remove the water filter.
If you have questions about your water pressure, call a licensed, qualified plumber.
Operat ng 27