Samsung SEF-36PZF User Manual page 38

WIRELESS FLASH
《38》
❹
❸
❶
❷
2
Place the other SEF-36PZF flash unit at the
desired location.
❶ Set the flash unit's power switch to
WIRELESS.
❷ Set the wireless mode switch to [S].
❸ Press the flash mode button and set the
flash mode to P-TTL mode.
❹ Set the zoom position to Manual [M. Zoom].
3
Check that the flash unit on the camera and the
slave flash unit(s) are ready and then take the
picture. (Ready lamp of the slave flash will
blink)
• The two flash units must be set to the same
channel otherwise the flash unit separated
from the camera will not fire.
• If the shutter speed exceeds X-sync speed
when the wireless mode of slave flash is set to
[A] or [M], the slave flash will not fire. To use
the X-sync mode, set the slave flash mode as
P-TTL mode.