Advertisement
Setting up the Projector Network Environment
3. Setting the Projector
Using Internet Explorer
Complete connections to external
equipment before starting the operation.
(See pages 23-27 of the projector's
operation manual.)
Complete the AC cord connection. (See
page 27 of the projector's operation
manual.)
1
1
Start Internet Explorer (version 6.0
or later) on the computer, and
enter "http://192.168.150.2/" in
"Address", and then press the
"Enter" key.
2
2
A screen for setting the projector
appears, set the each item.
User Name
Setting of user name for security
protection.
Password
Setting of password for security
protection.
Projector
Setting the projector name.
Name
Auto Logout
Setting the time interval in which
Time
the projector will be automatically
disconnected from the network
in units of a minute (from 1 to
65535 minutes). If the set value is
made 0, the Auto Logout function
is disabled.
Data Port
Setting the TCP port number
used when exchanging data with
the projector (from 1025 to
65535).
Search Port
Setting the port number used
when searching for the projector
(from 1025 to 65535).
-12
Note
•
When connecting the projector to the LAN, use
a commercially available LAN cable (UTP cable,
Category 5, cross-over type). When connecting
the projector to a hub, use a straight-through
cable.
Note
•
You can change the projector's IP address in
"TCP/IP" of the "Network" menu on the
projector.
Note
•
After setting items, wait for about 15 seconds
and then re-access.
•
User Name and Password can be up to 8
characters.
•
Projector Name can be up to 12 characters.
•
You can input the characters below:
a-z, A-Z, 0-9, -, _, (,), space
Advertisement
