Controlling The Projector Via Lan; Controlling The Projector Using Internet Explorer (Version 5.0 Or Later) - Sharp XG-PH70X Setup Manual

Controlling the Projector via LAN

After connecting the projector to your network, enter the projector IP address in "Address"
on Internet Explorer (version 5.0 or later) using a computer on the network to start a setup
screen that will enable control of the projector via the network.
Controlling the Projector
Using Internet Explorer
(Version 5.0 or later)
Complete connections to external equipment
before starting the operation. (See pages 24-
36 of the projector's operation manual.)
Complete the AC cord connection. (See page
37 of the projector's operation manual.)
Note
• When connecting the projector to the LAN, use a
commercially available LAN cable (UTP cable,
Category 5, cross-over type). When connecting
the projector to a hub, use a straight-through cable.
1
Start Internet Explorer (version 5.0
or later) on the computer.
2
Enter "http://" followed by the
projector IP address set by the
procedure on page
by "/" in "Address", and then
press the "Enter" key.
• The factory default setting for the projector :
"DHCP Client" is "OFF" and IP address is
"192.168.150.2". If you did not change the IP
address in "3. Setting up a Network Con-
nection for the Projector" (pages 21-22),
enter "http://192.168.150.2/".
3
A screen for controlling the pro-
jector appears, ready for per-
forming various status condi-
tions, control, and settings.
22 followed
-23