Network Printer Ip Address Configuration - Sharp AR-C200P Network Interface Manual

6. In the [Select Network Protocol] dialogue box, select [Internet
Protocol (TCP/IP)] then click [OK].
7. The Windows XP installation CD-ROM may be required. Follow
the remaining dialogue box prompts.
Once the protocol has been installed and configured in Windows, the
next step is to configure the TCP/IP parameters in the network printer.

Network printer IP address configuration

Use the Standard Set-up Utility to configure the IP Address, Subnet
Mask and Gateway.
Note: Some steps may not display depending on the network
protocols installed.
1. Connect the printer to the network and turn on.
2. Place the "Drivers" CD in the CD-ROM drive. The set-up utility
should start automatically. If the set-up utility does not start,
double-click on setup.exe in the Windows folder of the CD-ROM.
3. Select [Driver Installation].
4. Select [Network Card Quick Set-up].
5. Click [Next] at Welcome screen.
6. If you agree to the User Licence Agreement, click [Next].
7. Select the appropriate network card, using the Ethernet address
to identify it, and click [Next].
The Ethernet address of the printer can be found on the self-
diagnostic printout, which can be printed by pressing the push-button
on the network card panel for three seconds and then releasing it.
Do you use the TCP/IP protocol?
Microsoft Windows 9