Wired Network Setup; Set Ip Address; Automatic Setting; Manual Setting - Sharp DX-B351PL User Manual

4. Wired network setup

In case printers support wired network printing, they can be connected to network to
control printer to print in wired network mode.

Set IP Address

4.1.
The IP address of the printer may be automatically obtained through DHCP function or set
manually.

Automatic Setting

4.1.1.
DHCP automatic setting function is enabled by default on the printer.
1. Connect the printer to the network through a network cable and complete the startup
preparation work.
2. The printer will receive the IP address assigned by the server automatically. It may take
server minutes to receive an IP address under the influence of network environment.
You can check the IP address of the printer by printing the "Network setup page" out
(please refer to Chapter 7.4
control panel of the printer (please refer to
not listed, please check network environment and then try again after waiting for several
minutes.
• If DHCP server fails to assign IP address automatically, the printer
Note：
will get the link-local address assigned by printer automatically: 169.254.xxx.xxx.

Manual Setting

4.1.2.
To set up IP address for the printer through the control panel of the printer manually,
please refer to Chapter 7.2
To set up IP address for the printer through the embedded Web server manually,
please refer to Chapter 5.2.1
for printing method) or check network information by viewing the
Chapter 7.3
for details.
for details.
for viewing methods). If the IP address is
21