Central Machinery 44505 Set Up And Operating Instructions Manual page 4

8. USE RIGHT TOOL. Don't force tool or
attachment to do a job for which it was
not designed.
recOMMenDeD MiniMuM Wire
gauge FOr eXtensiOn cOrDs
(120 VOlt)
naMePlate
aMPeres
(at full load)
0 – 6
6.1 – 10
10.1 – 12
12.1 – 16
table a
9. USE PROPER EXTENSION CORD.
Make sure your extension cord is in good
condition. When using an extension
cord, be sure to use one heavy enough
to carry the current your product will
draw. An undersized cord will cause a
drop in line voltage resulting in loss of
power and overheating. Table A shows
the correct size to use depending on
cord length and nameplate ampere
rating. If in doubt, use the next heavier
gauge. The smaller the gauge number,
the heavier the cord.
10. WEAR PROPER APPAREL. Do not wear
loose clothing, gloves, neckties, rings,
bracelets, or other jewelry which may get
caught in moving parts. Nonslip footwear
is recommended. Wear protective hair
covering to contain long hair.
11. ALWAYS USE SAFETY GLASSES. Also
use face or dust mask if cutting operation
is dusty. Everyday eyeglasses only have
impact resistant lenses, they are NOT
safety glasses.
12. SECURE WORK. Use clamps or a vise
to hold work when practical. It's safer
than using your hand and it frees both
hands to operate tool.
Page 4
eXtensiOn cOrD
length
25' 50' 100'
18 16 16
18 16 14
16 16 14
14 12 Do not use.
For technical questions, please call 1-800-444-3353.
13. DON'T OVERREACH. Keep proper
footing and balance at all times.
14. MAINTAIN TOOLS WITH CARE. Keep
tools sharp and clean for best and safest
performance. Follow instructions for
lubricating and changing accessories.
15. DISCONNECT TOOLS before servicing;
when changing accessories, such as
150'
blades, bits, cutters, and the like.
14
16. REDUCE THE RISK OF
12
UNINTENTIONAL STARTING. Make
12
sure switch is in off position before
plugging in.
17. USE RECOMMENDED ACCESSORIES.
Consult the owner's manual for
recommended accessories. The use of
improper accessories may cause risk of
injury to persons.
18. NEVER STAND ON TOOL. Serious
injury could occur if the tool is tipped
or if the cutting tool is unintentionally
contacted.
19. CHECK DAMAGED PARTS. Before
further use of the tool, a guard or other
part that is damaged should be carefully
checked to determine that it will operate
properly and perform its intended
function – check for alignment of moving
parts, binding of moving parts, breakage
of parts, mounting, and any other
conditions that may affect its operation.
A guard or other part that is damaged
should be properly repaired or replaced.
20. DIRECTION OF FEED. Feed work into
a blade or cutter against the direction of
rotation of the blade or cutter only.
21. NEVER LEAVE TOOL RUNNING
UNATTENDED. TURN POWER OFF.
Don't leave tool until it comes to a
complete stop.
SKU 44505