Maintenance And Servicing; Cleaning, Maintenance, And Lubrication - Central Machinery 44505 Set Up And Operating Instructions Manual

Maintenance anD
serVicing
Procedures not specifically
explained in this manual must
be performed only by a qualified
technician.
FrOM acciDental
OPeratiOn:
turn the Power switch of the tool
to its "OFF" position and unplug
the tool from its electrical outlet
before performing any
inspection, maintenance, or
cleaning procedures.
tO PreVent seriOus injurY
FrOM tOOl Failure:
Do not use damaged equipment.
if abnormal noise or vibration
occurs, have the problem
corrected before further use.
cleaning, Maintenance, and
lubrication
1. beFOre each use,
general condition of the tool. Check for
loose hardware, misalignment or binding
of moving parts, cracked or broken parts,
damaged electrical wiring, and any
other condition that may affect its safe
operation.
2. aFter use,
the tool with clean cloth.
3. Warning! if the supply cord of
this power tool is damaged, it must be
replaced only by a qualified service
technician.
Page 12
tO PreVent
seriOus injurY
inspect the
wipe external surfaces of
For technical questions, please call 1-800-444-3353.
removing the chuck and spindle shaft
During this procedure, refer to the Chuck
and Spindle Assembly Drawing.
1. Pull the Feed Wheel counterclockwise
and hold the Chuck at a depth of three
inches.
2. Align the key holes in the Spindle Shaft
(B7) and the Quill Tube (B3) by turning
the Chuck by hand.
3. Insert a Wedge Drift Key (not supplied)
into the key holes.
4. Place a bundled cloth or basket below
the Chuck to catch it when it falls.
Lightly tap the Wedge Drift Key with a
rubber mallet until the Spindle Shaft falls
out of the Quill Tube.
installing the chuck and spindle shaft
1. Using a clean cloth, wipe the tapered
surfaces on the Spindle Shaft (B7).
2. Slide the Spindle Shaft and Chuck
assembly up and into the Quill Tube
(B3).
At the same time, turn the assembly until
the rectangular end of the Spindle Shaft
slips into the notch on the Quill Tube.
Warning! in the previous step, if the
spindle shaft is not properly set in
the Quill Tube notch, it may fly out
during operation.
3. Loosen the Lock Handle Support (C2)
and raise the Table (C7) about three
inches below the Chuck.
4. Turn the Chuck sleeve clockwise to open
the jaws completely.
5. Pull the Feed Knob counterclockwise
and force the Chuck against the Table
until the Spindle Shaft is secure.
SKU 44505