Attaching The Belt Clip - Gigaset SX100 isdn Instructions Manual

Preparing to use your phone
Registering the handset and charging the batteries
When you place the handset into the base, it automatically registers. This can be done
as follows:
1. Place the handset turned off in the base with the display up.
2. Wait till the handset has automatically registered with the base (page 134): This
takes about one minute. You will now see "Time not activated" in the display. The
handset is assigned the internal number 11 (the first valid internal number for
handsets) and the internal name Internal 11 appears in the display. You can change
the handset name (page 116).
If automatic registration is interrupted, you must register the handset manually as
described starting on page 134. There is a table of the most important questions
and answers to help you (page 147).
Now leave the handset in the base for the batteries to charge – the batteries are supplied
uncharged. The charging is indicated in the upper right of the display where the
charging status V flashes:
= The batteries are (almost) flat
e Batteries
i
If you want to register further handsets, please turn to page 134.
Note
Your telephone is now ready for use. With the Gigaset SX150isdn, the answering
machine with pre-recorded announcement is also activated. To correctly record the time
of calls and, if applicable, messages you must now set the date and time. Depending on
the network provider, the date and time are updated automatically by the telephone
network with every outgoing call. All the settings necessary for operating the telephone
can be set up easily with the Getting started wizard (page 14).

Attaching the belt clip

Push the belt clip onto the back of the handset until the lugs click into the recesses on
either side of the handset.
10
1
/ charged
3
V Batteries
2
/ charged
3
U Batt. fully charged