Polaroid FLM-1000WL User Manual page 22

Using the Wireless
System
Channel FineTune Operation
You can adjust the current channel by using the TV FINETUNE feature to adjust the
TV's image and audio quality to finally get the best viewing.
•
Panel button mode:
In the TV status, press the Menu button continuously. The screen will display
[Fine Tune Channel], press the CH
[Fine Tune Channel >>>], press the CH
display [Fine Tune Channel <<<].
•
Remote control mode:
In the TV status, press the WIFI menu button. The screen will display [Fine Tune
Channel], press the CH+ continuously.
Channel >>>], press the CH- continuously, the screen will display [Fine Tune
Channel <<< ].
BITRATE Operation
Bitrate setup is helpful for image quality and transmission distance. High bitrate: image
is more clearly suitable for near distance viewing. Low bitrate: the wireless transmission
distance is further, suitable for far distance viewing. Please set the bitrate to low, if the
quality of image transmission is bad.
•
Panel button mode:
In the TV status, press the Menu button continuously. Tthe screen will display
[MPEG Bitrate High], press the CH /
Bitrate High], [MPEG Bitrate Mid], [MPEG Bitrate Low]. Press the INPUT/ENT
button to confirm.
•
Remote control mode:
In TV status, press the WIFI menu button. The screen will display [MPEG Bitrate
High], press the CH+ or CH- button, the screen will display [MPEG Bitrate High],
[MPEG Bitrate Mid], [MPEG Bitrate Low]. Press ENT button to confirm.
Scan for signal
You can rescan the signal through the following operation:
•
Panel button mode:
In the TV status, press the Menu button continuously, the screen will display [Scan
For Signals OFF], press the CH /
the INPUT/ENT button to start the signal scanning.
•
Remote control mode:
In the TV status, press the WIFI menu button continuously, the screen will display
[Scan For Signals OFF] item, then press the CH+, or CH- button to select [Scan
For Signals ON] item, press the ENT button to start the signal scanning.
button continuously until the screen displays
button continuously. The screen will
The screen will display[Fine Tune
button, the screen will display [MPEG
button to select [Scan For Signals ON], press
- 21 -