Card Thickness Control Lever; Card Output Hopper - Polaroid P100I User Manual

Polaroid
General Information
Getting Started
Operation
Printing a Card
Cleaning
Troubleshooting
Specifications
Appendix A
Appendix B
Appendix C
13
C -

CARD THICKNESS CONTROL LEVER

This item is operated by the user to prevent more than one card feeding
into the printer at the same time and causing a jam.
Card Thickness:
A - 60mil (1.524mm) to 50mil
(1.27mm)
B - 40mil (1.016mm)
C - 30mil (0.762mm)
D - 20mil (0.508mm)
E* - Less than 20 mil (0.508mm)
* Start at lowest position and move
lever up to match card thickness.
For other card thickness, start lever at
lowest position and move up until
cards feed.
D -

CARD OUTPUT HOPPER

This item is used for collecting printed cards.
P100i
User's Manual
Open Cover, and adjust lever to correct
position. Repeat for different card
thickness.
(Factory setting is for 30mil (0.762mm)
card thickness). See diagram below:
Install Card Output Hopper onto printer by
hooking over bottom edge of card exit
aperture.