Performing The Initial Power-On Settings; Tv Controls; Automatically Searching And Storing The Channels - Polaroid LCD TV User Manual

6

Performing the initial power-on settings

6.1-TV controls

6.1.1-Temporary on/off (STAND-BY)
When you press the red STAND-BY
button located on the upper right
hand side of your remote control
+
while your television is switched on,
P
the sound and the picture will go off.
In the stand-by mode, the power
P
-
indicator of your television will glow
brighter. To switch your television
back on, either press any numeric button or
P+/P- buttons.
Caution! If you are not going to use your
television for a long time, unplug its power
cable from the socket.
6.1.2-Program selection
You may switch to the previous or
+
next program by pressing the P-/P+
P
buttons located on your television and
your remote control. You may enter
P
the number of the program you would
-
like to select using the numerical
buttons. For example, to switch
to the program number 12, press
respectively the numeric buttons 1
and 2 on your remote control. You
can perform the program selection
also from the Program Table. See page 9 for
the program table.
6.1.3-Temporary sound mute
(MUTE)
To temporarily mute the sound of
your television, press the MUTE
button on your remote control. In that
V O L +
case, MUTE symbol will appear on
the screen. When you press the same button
a second time, the sound will be restored. If
you press the VOL+ button while in the Mute
mode, the sound level is increased and the
Mute function is aborted.
6.1.4-Returning to Selected Program
(SWAP)
Allows you to switch between the
current program you watch and the
last selected program. For example, if
you change the channel to Program 11 while
you were watching Program 1, press SWAP
button to switch back to Program 1. Press
SWAP button to switch back to Program 11
again.
� � ∞±
6.1.5-Main Menu
Press the MENU button. The Menu
including all the setting menus will
appear on the screen. Navigate
through the Menu titles with the P+/P-
movement buttons and press the OK button
to select the desired menu. If you want to
exit the menu in any step, or return to the
previous menu while you are in a sub menu,
just press the MENU button.
MAIN MENU
PICTURE
PROGRAM TABLE
SETUP
FEATURES
6.2-Automatically searching
and storing the channels
You can either tune the programs
automatically or manually and store them in
your television.
Note: If your television does not receive any
antenna broadcast for a period of 5 minutes,
it automatically switches to the stand-by
position. The countdown symbol is displayed
on the screen during the last 1 minute.
You can tune the programs
automatically with the Autoprogram
function of your television and then
+
sort the channels as you desire by
P
means of the Program Table. Press
the MENU button on your remote
P
-
control. Select SETUP by pressing
the P- movement button and confirm
your selection with OK button.
Setup menu is displayed. Select
PROGRAM NO by pressing the P+/P-
movement buttons in Setup menu, enter the
channel number to be searched and stored
automatically, select AUTOPROGRAM
using the P+/P- movement buttons and
8 I
k
� � ±± � � ∞±
� � � �
SELECT
EXIT