Contact With Liquid; Questions And Answers - Gigaset A120 Manual

General specifications
Range
Mains unit
Operating temperature +5 °C to +45 °C
Dimensions/Base
Dimensions/Handset
Weight/Handset
Weight/Base
Re-chargeable battery
pack
Battery pack re-order
number
Battery pack capacity
Charging time
Calling time
Standby time
Care
Wipe the base station and handset with a damp
cloth or an antistatic wipe. Never use a dry cloth!
This can cause static!

Contact with liquid

If the handset has come into contact with liquid:
1 Switch the handset off and remove the bat-
tery pack immediately.
2 Allow the liquid to drain from the handset.
3 Pat all parts dry, then place the handset with
the battery compartment open and the keypad
facing down in a dry, warm place for at least
72 hours (not in a microwave, oven etc.).
4 Do not activate the handset again until it is
dry.
When it has fully dried out you will normally be
able to use it again.

Questions and answers

If you have any queries about the use of your tele-
phone, go to
www.siemens.com/gigasetcustomercare
for assistance 24/7. The table below contains a list
of common problems and possible solutions.
Problem Cause
Nothing The handset is not
appears in the switched on.
display.
Battery pack is
flat.
up to 300 m outdoors, up to
50 m indoors
230 V ~/50 Hz
115 x 74 x 87 mm (W x L x H)
51 x 155 x 35 mm (W × L × H)
approx. 102 g (excluding bat-
tery pack)
approx. 116 g
NiMH, 2xAAA Pack
V30145-K1310-X359,
A5B00075178739
550 mAh
approx. 10 hours in base
approx. 10 hours
approx. 140 hours (6 days)
!
Solution
Press the end call
a
key for approx.
5 seconds or place
the handset in the
base.
Charge/replace the
battery pack (page 2).
7
Problem Cause
No response The keypad lock is
to key press, activated.
"HOLD KEY"
appears in the
display.
No wireless The handset is
connection to outside the range
the base, dif- of the base.
ferent icons The handset is not
flash in the registered.
display. The base is not
switched on.
Cords not routed
correctly
Authorisation
This device is intended for analogue phone lines in
your network.
Country-specific requirements have been taken
into consideration.
We, Siemens Home and Office Communication
Devices GmbH & Co. KG, declare that this device
meets the essential requirements and other
relevant regulations laid down in Directive 1999/5/
EC.
A copy of the 1999/5/EC Declaration of Conformity
is available at this Internet address:
http://www.siemens.com/gigasetdocs.
Solution
R
Press the hash key
for approx. 2 sec
(page 3).
Move the handset
closer to the base.
Register the handset
(page 4).
Check the power con-
nector at the base
(page 2).
Check cord routing
(page 2).