Table of Contents
Advertisement
Recording from a Satellite Receiver
RAM -R -R DL -RW(V) +R +R DL +RW
Manual Recording
Preparation:
•
Insert a disc with enough remaining blank space
(➔ 14).
•
If the disc is protected, release protection
RAM
(➔ 48).
•
Connect a satellite receiver to this unit's input
terminals (➔ 9).
•
When the output signal from the external
equipment is NTSC, change the "TV System" to
"NTSC" in the Setup menu (➔ 55).
This unit cannot record NTSC signals to discs that
already have PAL signal recordings.
With the unit stopped
to select "AV2" for the
satellite receiver you have
connected.
to select the recording
mode.
Select the channel on the satellite
receiver.
to start recording.
Tips
To skip unwanted parts
Press [ h PAUSE] to pause recording. (Press again to restart
recording.)
To stop recording
Press [ g STOP].
Linked timer recordings with
external equipment (SKY Digital
STB/satellite receiver)–EXT LINK
To record programmes from a SKY Digital STB/satellite
receiver using timer programming
Preparation:
•
Insert a disc with enough remaining blank space
(➔ 14).
•
RAM
If the disc is protected, release protection
(➔ 48).
•
Make sure you connect the AV2 input terminal of
this unit to "VCR Scart Terminal" of a SKY Digital
STB/satellite receiver with a 21-pin scart cable
(➔ 9).
•
Set the "AV2 Input" and "Ext Link" to match the
connected equipment in the Setup menu (➔ 55).
Make timer programming on SKY
Digital STB/satellite receiver.
–
Refer to the equipment's operating
instructions.
–
The unit turns off and "EXT-L" lights on the
unit's display to indicate timer recording
standby has been activated.
–
While the unit is in EXT LINK standby mode
or recording, most operations on this unit are
prohibited ([ ; OPEN/CLOSE], [ 8 ] etc.).
When you operate, press [EXT LINK] to
cancel EXT LINK standby mode or recording
(The unit turns on and "EXT-L" disappears.).
Tips
To cancel the external control
Press [EXT LINK] to stop recording or to cancel linked timer
recording standby (The unit turns on and "EXT-L" disappears.).
Manual timer recordings (➔ 27)
Notes
•
In order to prevent accidental operation, press [EXT LINK] to cancel
the setting after recording is finished.
•
This function does not work when "TV System" is set to "NTSC" in
the Setup menu (➔ 55).
•
This function does not work with some equipment. Refer to the
equipment's operating instructions.
•
The beginnings of recordings may not be recorded correctly in
some cases.
•
When "Ext Link" is set to "Ext Link 2", this function does not work if
the input signal is NTSC system.
•
Programmes are recorded as one title on this unit when the end
time of the earlier timer recording and the start time of the later
timer recording are close to each other.
To divide the titles, go to "Divide Title" (➔ 42).
RAM
•
While the unit is in EXT LINK standby mode or recording, AV1
output terminal outputs the signal which is input from the AV2 input
terminal irrespective of "AV1 Output" setting (➔ 55).
25
RQT9118
Advertisement
Table of Contents
