Pre-Start Instructions - Central Pneumatic 95498 Set Up And Operating Instructions Manual

To Add Compressor Oil:
1. IMPORTANT! Prior to first using the Compressor, the Compressor MuST be
filled with a high quality S.A.E. 15W-30w grade non-detergent compressor oil.
(See Figure E.)
2. To do so, unscrew and remove the Oil Breather Cap (25). Pour approximately 1/2
quart of compressor oil into the Oil Breather Cap hole. Do not overfill.
(See Figure E.)
3. Observe the level of compressor oil through the Oil Sight Glass (22). The oil level
should appear between the "MINIMuM" and "MAXIMuM" marks on the Indicator.
(See Figure E.)
4. If necessary, continue adding compressor oil, while re-checking the Oil Sight Glass
(22). Maintain oil level at the center of indicator in the Oil Sight glass.
5. When finished adding compressor oil, re-install the Oil Breather Cap (25) back into
the Oil Breather Cap hole.
SKU 95498

PRE-START INSTRuCTIONS

OIL BREATHER CAP
OIL SIGHT GLASS
For technical questions, please call 1-800-444-3353.
(25)
(22)
FIGuRE E
dESIREd LEVEL
Page 9