Direct Command Operation Using The Handset; Remote Operation - Panasonic KX-TG9120E Operating Instructions Manual

TG9120_40_50E(e).book Page 47 Wednesday, August 2, 2006 4:54 PM
Calling back (Caller ID
subscribers only)
If caller information was received for the call,
you can call the caller back while listening to
a message.
1
Press J during playback.
2
"Call Back" i L
Editing the number before calling back
1
Press J during playback.
2
"Edit and Call" i L
3
Edit the number. i L
Direct command
operation using the
handset
You can operate the answering system by
pressing dial keys, rather than navigating
through the menus. To use the following
commands, press J (centre of joystick).
i I i L
Key Direct commands
Repeat message (during
{1}
*1
playback)
Skip message (during
{2}
playback)
Enter the "Settings" menu
{3}
Play new messages
{4}
Play all messages
{5}
Play greeting message
{6}
Record greeting message
{7}{6}
Turn answering system on
{8}
Stop (recording, playback)
{9}
Turn answering system off
{0}
Erase this message (during
{*}{4}
playback)
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
I
Answering System Features
Key Direct commands
Erase all messages
{*}{5}
Erase greeting message
{*}{6}
*1 If pressed within the first 5 seconds of
a message, the previous message will
be played.

Remote operation

Using a touch tone phone, you can call your
phone number from outside and access the
unit to listen to messages or change
answering system settings. The unit's voice
guidance will prompt you to press certain
dial keys to perform different operations.
Important:
L In order to operate the answering system
remotely, you must first turn on remote
operation by setting a remote access
code. This code must be entered each
time you operate the answering system
remotely.
Turning remote operation on
A 3-digit remote access code must be
entered when operating the answering
system remotely. This code prevents
unauthorised parties from listening to your
messages remotely. After you store your
remote access code, remote operation is
possible.
1
J (centre of joystick) i I i L
2
"Settings" i L
3
"Remote Code" i L
4
To turn on remote operation, enter a
3-digit remote access code.
L To turn off remote operation, press
{*}.
5
L i {ih}
47