Setting Call Restriction - Panasonic KX-TG8421E Operating Instructions Manual

TG8421E(e).book Page 26 Tuesday, December 16, 2008 8:03 AM
Programming
– "Single Item": An entry/a menu
icon is shown on one screen in large
characters at a time.
The default setting is "Multi Items".
1
1 (centre of joystick) i N i
M
2
{V}/{^}: "Display Setup" i
M
3
{V}/{^}: "Display Mode" i M
4
{V}/{^}: Select the desired setting.
i M i {ih}
Note:
L When A is displayed as a right soft
key on the handset, you can
temporarily switch the display mode
by pressing A (page 13).
L When in multiple items display mode,
you can move screens by pushing the
joystick right or left, without scrolling
down or up through the list:
– Push the joystick right to go to the
next screen.
– Push the joystick left to return to the
previous screen.

Setting call restriction

You can restrict selected handsets from
dialling certain numbers. You can assign
up to 6 phone numbers to be restricted,
and select which handsets are to be
restricted. Storing area codes here
prevents the restricted handsets from
dialling any phone number in that area
code.
1
1 (centre of joystick) i ! i
M
2
{V}/{^}: "Call Restrict" i
M
3
Enter the base unit PIN (default:
"0000").
L If you forget your PIN, see page
52.
26
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
4
Set which handsets to be restricted
by pressing the desired handset
number.
L All the registered handset
numbers are displayed.
L Flashing numbers indicate call
restriction is turned on for the
corresponding handset.
L To turn call restriction off for a
handset, press the number again.
The number stops flashing.
5
M
6
{V}/{^}: Select a memory location.
i M
7
Enter the phone number or area
code to be restricted (8 digits max.).
i M i {ih}
L To erase a restricted number,
press ^.
Changing the base unit PIN
(Personal Identification
Number)
Important:
L If you change the PIN, please make
note of your new PIN. The unit will not
reveal the PIN to you. If you forget
your PIN, see page 52.
1
1 (centre of joystick) i ! i
M
2
{V}/{^}: "Base Unit PIN" i
M
3
Enter the current 4-digit base unit
PIN (default: "0000").
4
Enter the new 4-digit base unit PIN.
i M i {ih}
Incoming call barring (Caller
ID subscribers only)
This feature allows the unit to reject calls
from specified phone numbers that you
do not want to answer such as junk calls.