Base Unit; Registering Handset To Base Unit - Panasonic KX-TG8421E Operating Instructions Manual

TG8421E(e).book Page 28 Tuesday, December 16, 2008 8:03 AM
Programming
Note:
L Calls are disconnected when the
handset moves from one radio cell to
another.
Registering a handset to a

base unit

The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base unit
(for example, w flashes even when the
handset is near the base unit), re-
register the handset.
1
Handset:
1 (centre of joystick) i N i
M
2
{V}/{^}: "Register" i M 2
times
3
{V}/{^}: Select a base unit number.
i M
L This number is used by the
handset as a reference only.
4
Base unit:
Press and hold {x} for about 5
seconds, until the registration tone
sounds.
L If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L The next step must be completed
within 90 seconds.
5
Handset:
Wait until "Base PIN" is displayed.
i Enter the base unit PIN (default:
"0000"). i M
L If you forget your PIN, see page
52.
L When the handset has been
registered successfully, w stops
flashing.
Note:
L When you purchase an additional
handset, refer to the additional
28
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
handset's installation manual for
registration.
Selecting a base unit
When "Auto" is selected, the handset
automatically uses any available base
unit it is registered to. When a specific
base unit is selected, the handset makes
and receives calls using that base unit
only. If the handset is out of range of that
base unit, no calls can be made.
1
1 (centre of joystick) i N i
M
2
{V}/{^}: "Select Base" i M
3
{V}/{^}: Select the desired base
unit number, or "Auto". i M
L The handset starts searching for
the base unit.
Deregistering a handset
A handset can cancel its own
registration (or the registration of
another handset) that is stored to the
base unit. This allows the handset to end
its wireless connection with the system.
1
1 (centre of joystick) i ! i
M
2
{3}{3}{5}
3
{V}/{^}: "Cancel Register" i
M
L The numbers of all handsets
registered to the base unit are
displayed.
4
Select the handset(s) you want to
cancel by pressing the desired
handset number. i M
L The selected handset number(s)
flashes.
L To cancel a selected handset
number, press the number again.
The number stops flashing.
5
{V}/{^}: "Yes" i M