Table of Contents
Advertisement
LCD (Touchscreen)
Handling the Touchscreen
Use the stylus included with the computer. Do not use an implement other than the stylus
that comes with the computer.
Do not place any object on the surface or press down forcefully with sharp-pointed ob-
jects (e.g., nails), or hard objects that can leave marks (e.g., pencils and ball point pens).
Do not operate the computer when such things as dust are on the LCD. Do not allow
substances such as oil to contact the LCD. The cursor may not work properly in such
cases.
When the LCD becomes dirty:
Wipe lightly to remove dirty areas by using a dry soft cloth.
Do not use benzene or thinner, or disinfectant-type alcohol.
Calibrating the Screen
Perform calibration if the cursor does not correctly move to the position where the stylus
touches the screen of the computer.
1
Tap [Start] - [Settings] - [Control Panel] in or-
der, and then double-tap [Stylus].
2
Tap [Calibration] - [Recalibrate].
3
"+" is displayed in the center, upper left, lower
left, lower right, and upper right portions of
the screen, in that order.
Each time the "+" mark is displayed, tap the center of
the "+" mark with the stylus.
After the calibration procedure is executed (i.e., after
the five "+" marks are touched), the procedure ends
when
is pressed.
4
Tap [OK].
Adjust the LCD Brightness
If the computer is operated in a dark place, the brightness of the screen can be adjusted to
view the screen.
1
Tap [Start] - [Settings] - [Control Panel] in order, and then double-tap [Back-
light].
2
Tap the [Brightness] tab and adjust the brightness with the slider.
3
Tap [OK].
16
Advertisement
Table of Contents
