Maintenance And Servicing - Central Pneumatic 90168 Set Up And Operating Instructions Manual

MaintenanCe and
seRViCing
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
FROM aCCidental
OPeRatiOn:
turn the Power switch of the
compressor to its "OFF"
position and unplug the
compressor from its electrical
outlet before performing any
inspection, maintenance, or
cleaning procedures.
tO PReVent seRiOus
injuRY FROM COMPRessOR
FailuRe:
do not use damaged
equipment. if abnormal noise
or vibration occurs, have the
problem corrected before
further use.
1. BeFORe eaCH use,
general condition of the Air Compres-
sor. Check for loose screws, mis-
alignment or binding of moving parts,
damaged electrical wiring, Tank, air
hoses/accessories (not included),
and any other condition that may af-
fect its safe operation.
2. at end OF eaCH WORKdaY:
Condensation will accumulate inside
the Tank (14). To prevent corrosion
inside the Tank, the moisture should
be drained at the end of each work-
day. To drain the moisture, Pull the
ring on the Safety Valve (3) to relieve
all remaining air pressure in the Tank.
SKU 90168
tO PReVent
seRiOus injuRY
inspect the
For technical questions, please call 1-800-444-3353.
Open the Drain (9) on the bottom of
the Tank, and tilt the Tank to allow the
moisture to drain. Then, make sure
to fully close the Drain.
3. tO Clean: Use a clean cloth and
mild detergent to clean the body
of the Air Compressor. Do not use
solvents. Do not immerse any part of
the Air Compressor in liquid.
4. WaRning! if the supply cord of
this power tool is damaged, it must
be replaced only by a qualified
service technician.
Page 11