Maintenance And Servicing; Cleaning, Maintenance, And Lubrication - Central Pneumatic 67697 Set Up And Operating Instructions Manual

b. Using a funnel to avoid spills, pour
enough oil into the Pump Crankcase
to reach the "full" level in the Oil Sight
Glass.
c. Replace the Oil Fill Plug.
Cold weather operation
Premium quality 30-weight, non-
detergent air compressor oil (sold
separately) is recommended for use
with this compressor pump. Start the
compressor pump in a heated area if
outdoor temperatures drop below 32°
F. If this is not practical, drain out the
old pump oil and use SAE 10W Non-
detergent Air Compressor Oil in the
pump crankcase instead whenever the
compressor pump's temperature will fall
below 40°. Do not use multi-viscosity
oil (such as 10W-30), they leave carbon
deposits on pump components and lead
to accelerated failure. Heavy operation
may require heavier viscosity oil.
If uncertain which oil to use, please call
Harbor Freight Tools customer service at
1-800-444-3353 for assistance.
wArnIng! To prevent serious injury from
burns: Do not add or change the oil
while the motor is in operation. Allow the
components to cool before replacing oil.
After filling with Oil, follow your air
compressor operation instructions
and safety warnings.
Change the compressor oil after the
first hour of use to remove any debris.
SKU 67697 For technical questions, please call 1-800-444-3353.
mAInTenAnCe And
SerVICIng
Procedures not specifically
explained in this manual must
be performed only by a qualified
technician.
From ACCIdenTAl
oPerATIon:
Turn off and disable the motor
before performing any
inspection, maintenance, or
cleaning procedures.
To PreVenT SerIouS Injury
From ComPreSSor FAIlure:
do not use damaged equipment.
If abnormal noise or vibration
occurs, have the problem
corrected before further use.
note: The following maintenance instructions
are for this Pump installed on a complete
compressor, including all needed
components (all sold separately).
Cleaning, maintenance, and
lubrication
1. beFore eACH uSe,
general condition of the Air Compressor.
Check for loose hardware, misalignment
or binding of moving parts, damaged
belts, cracked or broken parts, damaged
electrical wiring, and any other condition
that may affect its safe operation.
2. AFTer uSe,
the unit with a clean cloth.
3. wArnIng! If the supply cord
of this unit is damaged, it must be
replaced only by a qualified service
technician.
To PreVenT
SerIouS Injury
inspect the
wipe external surfaces of
Page 11