Indicators And Screen Messages - Panasonic DMP-B500 Operating Instructions Manual

Portable blu-ray disc player
Hide thumbs Also See for DMP-B500:
Table of Contents

Advertisement

Indicators and screen
messages
Indicators
The [CHARGE] indicator flashes rapidly.
There is a problem with the battery pack. Turn the unit on and
check the message on the LCD. (
Update of the firmware did not complete successfully.
Perform the update again. (
The [CHARGE] indicator flashes slowly.
Battery pack charge is low. The unit will turn off automatically
after a few minutes.
SD card access indicator is flashing
This unit is reading from the SD card, or writing to the SD
card. Do not remove the SD card from this unit.
Screen messages
Cannot read. Please check the disc.
Clean the disc. (
You inserted a disc that has not been finalized. (
ERROR U580
A problem has occurred with the battery pack. Consult your
dealer.
ERROR U581
The battery pack has been recharging but has failed to
recharge for some reason. Recharge again.
ERROR U582
You are recharging in a location that is too hot or too cold.
Recharge at normal temperature (i5 to i35 oC ).
U72
U73
There was a problem when connecting the HDMI.
jConnected device is not compatible with HDMI.
jUse a cable with an HDMI logo.
jThe HDMI cable is damaged.
U76
BD-RE, BD-R, BD-Video or DVD Video with copyright
protection cannot be played back since the device connected
to the HDMI terminal is not compatible with the copyright
protection.
U77
Video cannot be output since the copyright protection
information on the BD-RE, BD-R, BD-Video or DVD Video
being played back is not valid.
48
VQT2J83
below, 49)
35)
5)
F ∑∑
H ∑∑
(∑∑ stands for a number.)
A problem has occurred. (Numbers following the "F" or the
"H" will be different depending on the status of the unit) Turn
off the unit once, and turn it back on. Alternatively, turn off the
unit, disconnect the AC adaptor and the battery pack, and
attach them back again.
Authorisation Error.
This unit is not authorised to play this title.
[DivX]: You are trying to play the DivX VOD content that was
purchased with a different registration code. You cannot play
the content on this unit. (
Cannot play.
You inserted an incompatible disc. (
Cannot play on this unit.
You tried to play a non-compatible image. (
Re-insert the SD card.
No disc is inserted.
The disc may be upside down.
6)
Rental Expired.
[DivX]: The DivX VOD content has zero remaining plays. You
cannot play it. (
$ This operation is not available.
Some operations are unsupported by the unit. For example;
j[BD-V]: During playback, reverse slow-motion or reverse
frame-by-frame is not possible.
$ This operation is prohibited by this disc.
Depending on the disc, you may not be able to perform
search or skip when film previews and warning screens are
being played back.
Cannot connect.
Please check the connection of the LAN cable.
When a hub is used but its Link lamp does not light up, check
the cable connection, LAN terminal connection, cable itself (a
crossover cable may have been used by mistake), etc.
(
31)
IP address is not set.
The "IP Address" in "IP Address / DNS Settings" is "---. ---. ---
. ---". Set the "IP Address", "Subnet Mask" and "Gateway
Address". (Select the automatic address acquisition if
necessary.) (
24)
6)
24)
42)
46)

Advertisement

Table of Contents
loading

Table of Contents