Panasonic Viera TX-P42UT50E Operating Instructions Manual page 95

USB connection
When using USB cables, use the supplied Ferrite core (Middle size) for each cable to comply with the EMC standard.
As for installing the Ferrite core, refer to the installing of the Ferrite core for headphones.
It is recommended to connect the USB Flash Memory or Communication Camera to the TV's USB ports directly.
Some USB devices or USB HUB may not be used with this TV.
You cannot connect any devices by using USB card reader.
You cannot use two or more same kind of USB devices simultaneously except USB Flash Memory.
Additional information for USB devices may be on the following website. (English only)
http://panasonic.jp/support/global/cs/tv/
USB Keyboard
The USB Keyboard requiring its driver is not supported.
To change the language type
Characters may not be displayed correctly on the TV screen depending on the connected keyboard or the keyboard
layout setting.
Some of the keys of USB keyboards may correspond to the operation of the remote control.
USB Keyboard
n  p  m  o
Enter
Backspace
Esc
0 - 9 / Character
F1
Gamepad
Check the gamepads that have been tested for the performance with this TV at the following website. (English only)
http://panasonic.jp/support/global/cs/tv/
Some of the keys of gamepads correspond to the operation of the remote control.
Example:
1 2
Select Start
11 10 9 8 7 6
Input signal that can be displayed
COMPONENT (Y, P
B
Signal name
525 (480) / 60i, 60p
625 (576) / 50i, 50p
750 (720) / 60p, 50p
1,125 (1,080) / 60i, 50i
1,125 (1,080) / 60p, 50p, 24p
PC (from HDMI terminal)
Signal name
640 × 480 @60 Hz
1,280 × 720 @60 Hz
1,920 × 1,080 @60 Hz
Note
Signals other than above may not be displayed properly.
The above signals are reformatted for optimal viewing on your display.
PC signal is magnified or compressed for display, so that it may not show fine detail with sufficient clarity.
[USB Keyboard Layout] (p. 45)
Remote Control
Cursor buttons
OK
BACK/RETURN
EXIT
Numeric buttons
GUIDE
Remote Control
1 Volume Up / Down
2 Channel Up / Down
3
4 3 GUIDE
5
4 OK
5 BACK/RETURN
6 INTERNET
, P ) (from AV2 terminal), HDMI
R
COMPONENT
Horizontal frequency (kHz)
Applicable input signal for PC is basically compatible to HDMI standard timing.
USB Keyboard
F2
F3
F4
F5 / F6
F7 / F8
F9 / F10 / F11 / F12
7
8
9
10
11
31.47
45.00
67.50
(p. 89)
Remote Control
VIERA TOOLS
MENU
INPUT (AV)
Channel Down / Up
Volume Down / Up
Coloured buttons
Remote Control
VIERA TOOLS
EXIT
INPUT (AV)
MENU
Cursor buttons
HDMI
: Applicable input signal
Vertical frequency (Hz)
60.00
60.00
60.00
95