Panasonic Viera TX-P42UT50E Operating Instructions Manual page 42

Menu Item
Software Update
New Software Message
Network Status
Timer Programming
Off Timer
Auto Standby
Eco Navigation
VIERA Link
HDMI Content Type
AV1 out
Power on Link
Power off Link
Standby Power
Save
42
Adjustments / Configurations (alternatives)
Checks for available software updates from the Panasonic website
Selects whether to give a notification message when new software is found via
network [Off] / [On]
Displays the network status (MAC Address, current network settings, etc.)
Sets a timer to record or remind forthcoming programmes (p. 52)
For DVB mode
Sets the duration of time until the TV automatically goes into Standby mode
[Off] / [15] / [30] / [45] / [60] / [75] / [90] (minutes) (p. 22)
Sets the duration of time that the TV will remain on when no operation is
performed [Off] / [2] / [4] (hours)
Starting Timer Programming automatically does not affect this function.
Automatic input switching with the connected equipment affects this function
and time-count will be reset.
The notification message will appear 3 minutes before going into Standby mode.
Automatically sets the TV to the most suitable energy-saving mode
If you press the OK button, the following items are set as below:
[Eco Mode], [VIERA Link], [Power off Link], [Standby Power Save],
[Power Save] [On]
[Intelligent Auto Standby]
[Auto Standby] [2 hours]
Sets to use VIERA Link functions [Off] / [On] (p. 83)
Automatically adjusts the picture settings according to the received HDMI content
via HDMI cable [Off] / [Auto]
This function is available if the connected equipment supports HDMI Content
Type.
The content type information will be displayed for several seconds when this
function works.
Chooses the signal to be transmitted from the TV to Q-Link
[TV] / [AV2] / [Monitor]
[Monitor]: Image displayed on screen
Component and HDMI signals cannot be output.
Sets to use Power on Link function [Off] / [On] (p. 82, 83)
Sets to use Power off Link function [Off] / [On] (p. 82, 83)
Controls the connected equipment to reduce power consumption in Standby
[Off] / [On] (p. 84)
This function is available when [VIERA Link] is set to [On] and [Power off Link]
is set to [On].
[On (No reminder)]