Set Dvb Channel Manually [Manual Tuning - Panasonic Viera TX-P42UT50E Operating Instructions Manual

Set DVB channel manually [Manual Tuning]

Normally use [Auto Setup] or [Update Channel List] to retune DVB channels.
If tuning has not been done completely or for adjusting the direction of the aerial, use this function.
All channels found will be added to the Channel List.
DVB-C:
1
Enter the frequency
DVB-C Manual Tuning
Frequency
Symbol Rate
Service ID
Start scan
Signal Quality
Signal Strength
No. Channel Name
Normally set [Symbol Rate] and [Service ID] to [Auto].
DVB-T:
1
Adjust frequency for each channel
DVB-T Manual Tuning
Frequency
Signal Quality
Signal Strength
No. Channel Name
Set where the level of [Signal Quality] becomes the maximum.
Set Analogue channel manually [Manual Tuning]
[Fine Tuning]:
Use to make small adjustments to the tuning of an individual programme (affected by weather conditions, etc.).
[Manual Tuning]:
Set Analogue channel manually after Auto Setup.
Set [Sound System] and [Colour System], and then perform this function. Normally set [Colour System] to [Auto].
If a VCR is connected only with the RF cable, select channel position [0].
Analogue Manual Tuning
1 BBC1
Fine Tuning
Manual Tuning 2
Sound System
Colour System
Store
1
Select the channel position
3
Search
50
4 74,00 MHz
Auto
Auto
100%
100%
Type New
[CH21] 474,00 MHz
100 %
100%
Type New
SC1: PAL B, G, H / SECAM B, G
CH33
SC2: PAL I
78 1 41
SC1
SC3: PAL D, K / SECAM D, K
Auto
F: SECAM L, L'
2
Select [Start scan]
select
access
select channel
adjust frequency
2
Select the channel
4
Select [Store]
select
store
2
Search