On Screen Messages - Panasonic Viera TX-P58V10B Operating Instructions Manual

On screen messages

Message
All tuning data will be erased
Are you sure ?
Are you sure you want to delete this timer ?
Press OK to delete timer
Press RETURN to return
Bad signal
Child Lock is active !
Press OK to enter PIN.
Ethernet cable not connected
Faulty dish
Feature not available
Found new software version
Press OK to start update
(may take 40 mins)
or Press EXIT to ignore
and you can update when TV is in standby.
Gateway does not answer.
Please confirm connection and setting of
router.
Invalid operation - Please check settings
and connections.
Invalid system time. Please exit !
IP address conflict
IP address not set
●
"Shipping Condition" will erase all tuning data (p. 46).
●
Confirm correct operation.
●
Confirm correct operation.
●
The signal is weak. Check the aerial is plugged in properly. It may
be necessary to have an aerial installer check the signal and aerial
alignment.
●
Reset channels. (p. 34 and p. 35)
●
The selected channel is locked in Child Lock (p. 45). You must enter the
PIN number before the channel will be displayed.
●
Check the connection of the LAN cable. If you use a hub, also check the
light on the hub is lit.
●
The LAN cable might be defective.
●
The satellite cable might be short-circuited or there might be connection
problems of the cable. Check the cable and connection and then turn the
TV Off with the Mains power On / Off switch, and turn it On again.
●
If the message still persists, it may be necessary to have a dish installer
check the dish and cable.
●
It is not possible to record from COMPONENT, HDMI or PC. Connect the
recorder to the TV using a fully wired SCART cable for recording from the
TV tuner.
●
Confirm Q-Link or VIERA Link settings (p. 66 - 69).
∗∗∗
.
●
There is a new software available.
●
A connection failure has occurred and the gateway is not responding.
Check the settings and connections of the router.
●
Turn the TV and the router Off with the Mains power On / Off switch, and
turn them On again.
●
Check the Q-Link or VIERA Link connection and setting (p. 66 - 69).
●
Cannot get the time information. Check the connection of the RF cable.
●
Duplicate IP address has been detected. Check the IP address of other
equipment such as computers, routers and ensure that there are no
duplicate IP address.
●
An IP address is required to use interactive content through the internet.
Enter an IP address.
Meaning / Action
85