Table of Contents
Advertisement
INSERTING THE BATTERIES
1
Slide the battery chamber cover as shown in
the figure to remove.
10
2
Insert four AA-size batteries, making sure the
plus/minus marking(
, , . ) match the diagram
inside the battery chamber cover.
35
mm
A.Zoom
P-TTL
mm
0.7 1 1.5 2
3
4
6
8
12 16 22m
2.3
5
10
20
40
70ft
FIX
3
When the power switch is set to the [ON]
position, the Ready Lamp lights up indicating
that the flash has been charged and is ready to
fire. Then, by pressing the Test Button, the test-
flash will fire. Auto check confirmation can be
done in the Auto flash mode but cannot be
done in the TTL or P-TTL mode.
BATTERIES
This flash unit operates with four AA-size batteries
as shown below.
Alkaline battery
: LR6
Lithium battery
: FR6
Nickel Hydroxide battery : Ni-MH
The flash unit charges in approximately 6 seconds
with brand new alkaline batteries, 5 seconds with
Nickel Hydroxide battery and 6 seconds with lithium
batteries. If charging time takes more than 20
seconds, then the batteries are weak and should be
replaced with the same type of new batteries.
• If the batteries are not inserted properly, the
Ready Lamp will not light up. Insert the
batteries correctly.
• If you let the flash unit fire in succession on
lithium batteries, heated batteries would
activate the safety circuit so that the firing is
temporarily disabled.
In this case, take time to reduce the battery
temperature and it would bring you back to the
normol condition of use.
11
Advertisement
Table of Contents
