Table of Contents
Advertisement
• When using a flash unit separated from the
camera, use of the Off-camera shoe adapter F
or the Off-camera shoe clip CL-10 is
recommended.
• Keep the distance from the built-in flash and
the AF360FGZ to the subject within 4 meters.
38
35
SLAVE
mm
P-TTL
mm
M.Zoom
7
5
3
1
2
I Procedure
1
Set the flash unit's power switch to WIRELESS.
2
Set the WIRELESS mode switch to [S].
3
Slide down the setting switch to the [yellow
dot]. Then press the [CH.] channel button to set
the same channel as camera. Slide the setting
switch up. See page 48 for Setting the channel.
4
After setting the channel, attach the flash unit
to the camera's hot shoe and turn on the
camera. Press the shutter button halfway. The
camera's flash channel will then be set.
5
Press the flash mode button and set the flash
mode to P-TTL mode.
6
Place the flash unit at the desired location.
7
Set the zoom position with Manual [M. Zoom]
8
Turn on the camera and ready the built-in flash.
While pressing the camera's flash function
button, turn the select dial until W appears.
9
Check that both the AF360FGZ and built-in
flash are ready, then take the picture.
• In the P-TTL mode, the flash amount
adjustments
[1/1,2/3,1/2,1/3]
and
flash
exposure
compensation
[-3.0~+1.0]
possible. (Refer to page 46)
• The camera side must be set to the wireless
(W) or the AF360FGZ will not fire.
• The built-in flash can be used as other than
main flash, refer to the camera-operating
manual for setting the custom function.
• When using with *ist or MZ-S, test flash can be
performed before shooting to confirm that the
flash fires in wireless control mode, refer to
the camera-operating manual for setting the
custom function.
are
39
Advertisement
Table of Contents
