Indicator Lamp - Makita HR4001C Instruction Manual

1
2
1. Power-ON indicator lamp (green)
2. Service indicator lamp (red)
ASSEMBLY
1
2
1. Side handle
2. Clamp nut
1. Side grip
8

Indicator lamp

006314
The green power-ON indicator lamp lights up when the tool is plugged. If the
indicator lamp does not light up, the mains cord or the controller may be defec-
tive. The indicator lamp is lit but the tool does not start even if the tool is
switched on, the carbon brushes may be worn out, or the controller, the motor
or the ON/OFF switch may be defective.
The red service indicator lamp lights up when the carbon brushes are nearly
worn out to indicate that the tool needs servicing. After approx. 8 hours of use,
the motor will automatically be shut off.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Side handle
003139
CAUTION:
• Use the side handle only when chipping, scaling or demolishing. Do not
use it when drilling in concrete, masonry, etc. The tool cannot be held
properly with this side handle when drilling.
The side handle can be swung 360° on the vertical and secured at any desired
006315
position. It also secures at eight different positions back and forth on the hori-
zontal. Just loosen the clamp nut to swing the side handle to a desired posi-
tion. Then tighten the clamp nut securely.
Side grip
006316
1
CAUTION:
• Always use the side grip to ensure operating safety when drilling in
concrete, masonry, etc.
The side grip swings around to either side, allowing easy handling of the tool in
any position. Loosen the side grip by turning it counterclockwise, swing it to the
desired position and then tighten it by turning clockwise.