Table of Contents
Advertisement
INSTALLATION INSTRUCTION
CONNECTING TO GAS
This appliance is designed to be installed with an appliance flexible connection only. Supply piping should not be
less that R³/8. Connection is made to the Rc ½ (½" B.S.P.) female threaded entry pipe located just below the
hotplate level on the rear left hand side of the appliance. NOTE: ONLY LIQUID SEALANTS TO BE USED WHEN
INLET GAS PIPE IS FITTED I.E.: DO NOT USE P.T.F.E. SEALANT TAPE. Check for gas soundness after
connecting to the gas supply. The gas bayonet connector must be fitted in the shaded area indicated in Fig.3. Take
into account that it must be possible to pull the appliance forward sufficiently. The hose must not get caught on the
stability bracket.
IMPORTANT: FLEXIBLE TUBING USED MUST COMPLY WITH BS. 669 CURRENT EDITION.
LPG Flexible connections must be a type suitable for L.P.G and capable of operation up to 50 mbar and carry a red
stripe, band or lable.
50
100
All dimensions in mm
Fig.3
35
Advertisement
Table of Contents
